INCLUDED IN KIT
2 high-quality custom hoses
hose ties/straps and protective loom included.
 
OPTIONAL 90-DEGREE TCV FITTING OR
ADD TWO FOR HOSES INSTALL AND ROUTING OPTIONS.
 
MUST NOTE at check out option if you have power steering or not so we can include the correct hoses.
 
This kit has been highly requested and now we have it offered to the public. This kit includes 2 high-quality hydraulic hoses with heavy-duty swivel fittings with correct angle ends. Many people prefer flexible hoses over hard lines for many reasons. One reason is that they can be much, much, easier to install. They offer more options for routing them. Also, they are much more cost-effective and cheaper to ship as well. This kit can be used to replace hardlines or soft lines. This kit can be used for new PTO installs or swaps.
 
We made it a universal kit that works with almost all Case Ingersoll Tractor model and PTO model combinations. That said, some combinations you may have a little bit of extra length and in others no extra. There is an option for a new 90-degree fitting for your travel control valve. If your tractor NEVER had a PTO installed you WILL almost always NEED this fitting for installation.
 
NOTE- If you have soft hydraulic hoses on your “existing” PTO, make sure your hose going into the inlet of PTO is connected to a shorter hose coming directly off your Hydraulic pump. IF your PTO feed “in” hose is 1 long hose directly from the pump to the PTO valve you will NEED to order the correct new hydraulic high pressure Pump hose for your model as this hose kit is designed to hook into the original factory pump hose that fed the travel control valve prior to the PTO being installed. This is ONLY and potentially for some EXISTING PTO installations ONLY WITH soft hydro lines AND ONLY if your feed line in  to PTO is “1” long hose, Select the correct new pump high-pressure hose for your tractor from our site if needed.   If you already have 2 hoses from the hydro pump you should be fine with this kit alone as is.   
Routing options vary by application and are up to the installer, some times the hoses can go over the axle, under the axle, or both. Often the line going to the pump may go over the axle and sometimes between the"Hi-Low" range linkage and frame. Any time hoses touch each other or touch anything they should have some kind of hose protection. Either a commercial product or simply cut an inner tube and wrap it around the hose.
 
The OPTIONAL 90 fitting is needed for new installs 99 percent of the time esspecially on 200, 400 and early 3000, 4000 series. Using 2 of these fittings can give you routing and conection options and differnt angles and postions for hoses and fitting clearances etc. 
 
Check out our install and info video. 
 
INSTALL TIPS- CHECK YOUR PTO MANUAL FOR PROPER INSTALLATION. YOU WILL NEED TO KNOW WHAT PORTS ON YOUR PTO ARE IN AND OUT/RETURN. The LONG 90* elbow goes to the optional 90* adapter (offered in the kit at check out )for the TCV. The 45* fitting goes to the bottom of most PTOs, The male hose end goes to your main Pump hose, and the SHORT 90* goes to the top/side of most PTOs. BUT CHECK YOUR SPECIFIC PTO MANUAL FOR THE CORRECT PORTS FOR IN AND OUT/RETURN