C26326 Steering Shaft With Roll Pin Kit
 
Steering Shaft with Gear 
For most 200/400  and early/mid 3000/4000 series Case Ingersoll tractors 
23 7/8'' Overall 
 
Included: gear welded on bottom AND new roll pin #138-143
NOT FOR Later production 3000/4000 series tractors which require a 25 3/8" length; order part number C33940
NOT a direct replacement WITHOUT modification for early models WITH steering wheels keyed to the shaft and retained by a nut.
 
OPTION- To add our steering shaft install kit. This kit includes Top Bushing, washers, spacers, shims that are used to space and position your shaft and lower gear for proper meshing with sector moon gear. Proper alignment and spacing makes for best steering and longevity of parts. These items are also wear items and SHOULD be replaced when replacing steering shafts. The shims and spacers are "USE AS REQUIRE" items. So each machine may require different amounts and or combinations of them to get desired result. The steering tube bushing should be replaced on all installs to make sure your shaft and both gears last and perform. Look at photos. Replaces or use with C15096, C12975, 195-541, 195-2069, 195-2206
 
OPTION- Add cross member Upgraded Oilite bushing to replace C27501. This is only for mid generation 200-400 models and all 3000-4000 series. Look at photo of correct cross member steering support that this busing goes in. We ALWAYS replace this with a new shaft otherwise new shaft and gear will wear fast and steering performance will also suffer.
 
OPTION- To add our "Poor Mans SHAFT Power Steering Assist" These thrust washers and bearing helps reduce friction and drag on your steering system and helps with steering effort. They are used in place or with the items in our "Steering Shaft Install Kit" above or currently on your tractor. In order to get the best benefit from this your steering shaft should have very little up and down movement so using the spacers and shims may be needed to achieve this But you DO NOT want it squeezing these so just the smallest amount of clearance/up and down movement is needed.  This bearing and washer kit can be used under the steering wheel OR on top of the steering gear on the bottom of the shaft. It depends where you need the base gear positioned to best mesh with the sector half moon gear. Note will work on many models but there is a possibility it may not work on your model depending on spacing available or where your gear engagement/meshing needs to be. Look at Photos. NOTE THIS IS NOT The traditional "steering SPINDLE" poor mans power steering. We have listings for those kits as well and this can be used with that kit too.
 
There is an OPTION to add a new main half moon steering gear kit to your order. They are best replaced together for longevity. 
 
NOTE: If your steering wheel is held on with a threaded nut AND key, this shaft can be used to replace your current shaft. You will either have to buy a replacement steering wheel with a roll pin attachment or you can drill out your current keyed and nut attached steering wheel to accept the roll pin
 
Due to length we have to ship these in a larger box